Once you have your ID Kit (or while its headed to you) you’ll need to begin outlining your ID card layout. When you have everything prepared to make a go at utilizing your ID card pack is simple. You will need to arrange your product to print in the right area on the Teslin sheet, then print the front and back of your ID. After this you just punch the ID out of the sheet (cautious to not extend or tear it), and spot it within a butterfly pocket. The addition ought to fit into the butterfly pocket impeccably so no edges are standing out. Presently turn your laminator on and permit it to warmth it. On the off chance that your laminator obliges the utilization of a transporter put the butterfly pocket (with the Teslin within it) in the bearer. Presently, simply run it through the hot laminator included in your pack, you will have a strong, borderless ID Card. As of right now you can add a visualization overlay to your ID card by uprooting the glue support and sticking it to the ID card. Congrats, you’ve made your first ID card!